Passenger's Dashboard Undercover Removal/Installation

Passenger's Dashboard Undercover Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program

NOTE:

- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the passenger's dashboard undercover (A).

1. Gently pull down the rear edge to detach the clips.

2. Disconnect the front passenger's footwell light connector (B).

3. Pull the undercover away to release the pins (C) from the brackets (D).





2. Install the undercover in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure footwell light connector is plugged in properly.
- Make sure the pins are installed securely in the brackets.
- Push the clips into place securely.