Cigarette Lighter

Cigarette Lighter

Special tools, testers and auxiliary items required

• Release tool (T40148)

Removing





- Switch off ignition and remove ignition key.

- Remove the front ashtray insert - 1 -, press button - arrow - to do so.

- Remove the bolt - arrow - and remove front ashtray housing.





- Unplug connector.

- The release tabs - 2 - on the (T40148) must engage in the openings on the cigarette lighter (U1) - item 3 - - arrow - and the threaded pin - 1 - must slide down as far as the stop.





- Slide the (T40148) into the cigarette lighter - item 1 - as far as the stop.





- Rotate the thumbwheel - 2 - on the (T40148) clockwise as far as the stop.

• The piston - 2 - is pulled upward and the release tabs - 1 - on the (T40148) spread - arrows -.





- Remove the cigarette lighter from the lighting ring using the (T40148).

- Release the clips in - direction of arrow -.





- Remove the cigarette lighter with the illumination ring - 1 - from the front ashtray - 2 -.

Installing





Install in reverse order of removal, observing the following:

• The new cigarette lighter must be connected to the cigarette lighter illumination bulb (L28) wiring harness.

- Disconnect the wire and connect the new cigarette lighter to the wire for the cigarette lighter illumination bulb.


Risk of injury.

• After removing the (T40148), check to see if the lighter retaining tabs are bent.

• If the retaining tabs are bend, bend them back so the lighter does not slide out.

- Remove the support - 1 - on the (T40148).

- Slide the piston down and hold it in place.

- Rotate the thumbwheel - 4 - on the (T40148) counterclockwise - arrow -. This loosens the release tabs - 2 - on the cigarette lighter - item 3 - so the (T40148) can be removed.

- Slide the cigarette lighter illumination ring into the mount until the retaining clips engage.

• The illumination ring can only be inserted in the mount in one position.