Rear A/C Control Head, Climatronic

Rear A/C Control Head, Climatronic

• At present, Rear A/C Control Head (Climatronic) (E265) can still be exchanged in the familiar manner, no component protection is active introduction of component protection not yet finalized Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.

Removing

- Check the adaptation of the Rear A/C Control Head (Climatronic) (E265) with the "Replace control module" function in Guided Fault Finding the control head will be replaced vehicle diagnosis, testing and information system VAS 5051 in the "Guided Fault Finding" function.

- Switch off ignition.

- Remove vents from rear center console - A -. Refer to=> Body Interior 68 Removal and Installation





- Disengage catch of connector - A - by lifting clip - B - and disconnect connector.





- Disengage connector - C - and disconnect it.

- Pull Rear A/C Control Head (Climatronic) (E265) - B - out of center console vent - A - clipped in.

Installing

Install in reverse order of removal.

- Check the DTC memory for the Rear A/C Control Module (Climatronic) (E265) and the Climatronic Control Module (J255) front A/C control head and erase any stored DTCs vehicle diagnosis, testing and information system VAS 5051 in the "Guided Fault Finding" function.

- Perform the basic setting, adaptation and output diagnostic test mode on the A/C system vehicle diagnosis, testing and information system VAS 5051 in the "Guided Fault Finding" function.