Outer Tail Lamps, From 09.07

Outer Tail Lamps, from 09.07

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Outer Tail Lamps

Removing





- Switch off ignition and remove ignition key.

- Turn light switch into "0" position.

- Unclip the cover plugs - 1 - and - 2 - from the luggage compartment trim.

- Remove nuts - 3 -.

- Push rear lamp outwards and disengage from retaining pin at body.

- Disconnect electrical harness connector at tail lamp.

Installing

Install in reverse order of removal, observing the following:

• Replace the double bolts if the sealing washer is damaged.

- Remove double-sided adhesive tape - arrow - at body cover panel and rear lamp.





- Attach new adhesive strip and remove backing.

- Position rear lamp from outside at retaining pin and press towards center of vehicle until it engages.

- Press body cover panel onto rear lamp to affix double-sided adhesive tape.

Tightening Specifications