Brake Pedal Mounting Bracket

Brake Pedal Mounting Bracket

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1410)

• Torque Wrench (V.A.G 1331)

Removing

- Remove cover on the driver side.

- move adjustable steering column all the way back (opposite direction of travel)

- Disconnect accelerator module connector - 1 -.

- Remove the brake lamp switch - 2 -. Refer to => [ Brake Light Switch ] Service and Repair.

- Remove the brake lamp sensor - 2 -. Refer to => [ Brake Lamp Sensor ] Service and Repair

- Disconnect brake pedal from brake booster. Refer to=> [ Brake Booster ] Service and Repair

- Disconnect connector - 1 - on Clutch Pedal Switch (F36).

- Disconnect connector - 1 - for Clutch Pedal Switch (F194).

- Remove multi-point socket head bolts - 1 -.

- Remove multi-point socket head bolts - 1 - and - 3 -

Tightening specification 25 Nm.

- Remove tower brace - 2 -.

• Do not remove brake fluid reservoir.

- Remove brake fluid reservoir locking bolt - 1 -.

- Disconnect connector - 1 -

- Press reservoir to side and remove fasteners - 1 -.

• Only affects vehicles with manual transmission.

- Remove hex socket head bolt - 1 -, tightening specification 25 Nm.

- Remove mounting bracket.

Remove gas pedal

Installing

Installation is the reverse of removal, with special attention to the following:

- First thread pins into mounting bracket and attach brake booster.

- Then install multi-point socket head bolts - 1 -

Clip brake pedal together with brake booster. Refer to => [ Brake Booster ] Service and Repair

- Hold ball head of push rod in front of mounting and push brake pedal in direction of brake booster, so the ball head locates audibly.

- Brake light switch, installing. Refer to=> [ Brake Light Switch ] Service and Repair

- Install the brake lamp sensor. Refer to => [ Brake Lamp Sensor ] Service and Repair.