Windshield Washer Fluid Reservoir Filler Neck

Windshield Washer Fluid Reservoir Filler Neck

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing





Vehicles through 05.08

- Remove the seal - arrow - near the windshield wiper fluid reservoir filler tube.

- Unclip the plenum chamber cover - 3 - and remove it.

• Ignore items - 1 and 2 -.

Vehicles from 06.08





- Remove the bolts - 3 -.

- Remove the clips - 2 - from the mounts and remove the plenum chamber cover- 1 -.

All Vehicles





- Remove the nut - 1 - and tilt the windshield wiper fluid container filler tube slightly upward - arrow A -.

- Remove the filler neck - 2 - with filler tube from the washer fluid reservoir and the body opening - arrow B -.

Installing





• Tightening specification, refer to => [ Windshield Washer Fluid Reservoir, Washer Fluid Lines and Nozzle Assembly Overview ] Windshield Washer Fluid Reservoir, Washer Fluid Lines and Nozzle Assembly Overview.

Install in reverse order of removal, observing the following:

- Slide the sealing grommet - 2 - on the filler neck tube - 1 - as far as the stop.

• The tab must lie in the opening on the filler tube - arrows -.

- Slide the filler neck into the washer fluid reservoir.

• Make sure the O-ring is not crushed when sliding it into the washer fluid reservoir.