Fan Shroud: Service and Repair

Fan Shroud

Removing






- Remove the front noise insulation - 1 -.

- Disconnect the radiator fan electrical connectors - 1 and 2 -, to do this, push the clamp to the rear - arrow - and push the release down.






- Remove the bolts - 1 and 2 - and remove the bumper cover noise insulation toward the rear.






- Remove the left and right bolts - 1 -.






• Ignore - arrow -.

- Remove the bolts - 1, 2, 3, 5 -.






- Lift the lock carrier cover - 4 - and hang it on the radiator grille.

- Remove the bolts - arrows -.






- Remove the air filter housing air guide - 1 - on the intermediate flange - 2 -.

- Release the clamps - arrow A - and tilt the power steering coolant hose - 1 - forward - arrow B -.






- Pull the power steering coolant hose upward off the condenser and lay it on the engine.

- Release the retaining tabs - A arrows - and tilt the left and right air ducts - 1 - toward the center of the vehicle - arrow B -.






• The installation location is shown with the bumper cover removed.

- Release the left and right radiator retaining pins and remove by pulling upward - arrows -.






- Pull the radiator on the left side toward the front - arrow B -, then push it to the left - arrow C - and finally pull the right side toward the front - arrow A -.






- Press the fan shroud left and right locking tabs at the same time - arrow - and remove the fan shroud upward from the radiator.






Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ Radiator and Coolant Fan Overview ] Radiator and Coolant Fan Overview.

- Install the bumper cover insulation.

- Install the air duct on the air filter housing intermediate flange.

- Install the lock carrier cover.

- Install the front noise insulation.