Clock: Service and Repair

Radio Frequency Controlled Clock Receiver

• All warning lamps in instrument cluster are fitted with light-emitting diodes. In case an indicator lamp is malfunctioning, the instrument cluster must be replaced.

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing





- Remove rear bumper cover.

- Remove the bolts - arrows - and the radio frequency controlled clock receiver (J489) - item 2 -.

- Disconnect the electrical connector - 1 - on the radio frequency controlled clock receiver.

Installing

• Tightening specification, refer to => [ Instrument Cluster Radio Frequency Controlled Clock Receiver Assembly Overview ] Instrument Cluster Radio Frequency Controlled Clock Receiver Assembly Overview.

Install in reverse order of removal, observing the following:

- Install the cover on the rear bumper.

Vehicles with lane change assist

If the bumper cover was removed, the lane change assistance control module (J769)/ (J770) must be calibrated again. Refer to => [ Lane Change Assistance, Preparing for Calibration ] Lane Change Assistance, Preparing For Calibration.