P0335

System/Component
Engine Position Sensor (crankshaft)

Fault Code
P0335

Fault Type
Plausibility Yes
Signal No
Minimum Threshold No
Maximum Threshold No

Monitoring Method
counting teeth of increment wheel(signal fault, tooths)

Signal Type
pulsating rectangular wave on/off-cycles with constant or varying on/off-times
ECM internal signal/value computation or comparison

Operating Range
yes/no

Time Length and Frequency for Monitoring/Diagnosis
once per revolution/permanent

Criteria for storing fault code
fault during 2 trips

Criteria for illuminating the MIL
fault during 2 trips and end of 2nd trip

Criteria used for determining out of range values and input component rationality check
UBATT No
Ground No
Disconnect No

Electronic Control Module (ECM)
1) If number to teeths are 57 or 59, fault is tolerable as long as no misfire is detected at the same time
2) If number of teeths are ≤ 56 or ≥ 60, reset to "0" and start again. If the same status occurs again, a fault is detected and the phase sensor is used as a reference.