P0705

System/Component
Transmission Range Sensor

Fault Code
P0705

Fault Type
Plausibility Yes
Signal Yes
Minimum Threshold No
Maximum Threshold No

Monitoring Method
Plausibility/check circuit

Signal Type
ECM internal signal/value computation or comparison

Time Length and Frequency for Monitoring/Diagnosis
25 sec/once per ignition key on

Criteria for storing fault code
fault during 2 trips

Criteria for illuminating the MIL
fault during 2 trips and end of 2nd trip

Criteria used for determining out of range values and input component rationality check
UBATT Yes
Ground Yes
Disconnect Yes

Electronic Control Module (ECM)
During start (n = 200 - 400 rpm) verify that gear lever is in position P or N, also the circuit continuity for D, 3, 2 is checked (same condition). If unavailable code is detected than always "D" is active.