Instrument Panel (IP) - Accessory Trim Plate Replacement

Trim Plate Replacement - Instrument Panel (I/P) Accessory

Removal Procedure





1. Remove the screws from the bottom of the I/P accessory trim plate.
2. Pull the I/P accessory trim plate rearward in order to release the retaining clips.
3. Rotate the I/P accessory trim plate rearward and up in order to release the 2 tabs at the top edge.
4. Disconnect the ash tray harness electrical connector from the I/P harness.
5. Remove the I/P accessory trim plate.



Installation Procedure

1. Connect the ash tray harness electrical connector to the I/P harness.




2. Align the accessory trim plate to the I/P.
3. Install the tabs into the I/P openings.
4. Rotate the I/P accessory trim plate forward and press the clips into the retainers until fully seated.

Notice: Refer toFastener Notice in Cautions and Notices.

5. Install the screws to the I/P accessory trim plate.

Tighten the screws to 2 Nm (18 lb in).