Pressure Plate: Service and Repair

REMOVAL PROCEDURE





1. Remove the manual transmission.
2. Remove the clutch pressure plate bolts (1).
3. Remove the clutch pressure plate (2) and driven disc (4) from the dowel pins on the flywheel (3).

INSTALLATION PROCEDURE

Tools Required
- J 33169 Clutch Alignment Arbor
- J 36660 Torque Angle Meter





1. Install the clutch pressure plate (2) and driven plate (6) to the dowel pins on the flywheel (5).

IMPORTANT: When the clutch driven plate requires replacement, the engine flywheel must also be replaced along with the clutch pressure plate as an assembly.

2. Match the gray paint spot (7) on the pressure plate (2) to the X (4) on the flywheel (5).
3. Install the clutch pressure plate bolts (1) finger tight.
4. Install the J 33169 in order to align the clutch driven plate to the clutch pilot bearing.
5. Tighten the clutch pressure plate bolts (1).
^ Tighten the clutch pressure plate bolts (1) to 20 Nm (15 ft. lbs.). Use J 36660 in order to tighten the bolts an additional 45 degrees.

NOTICE: Refer to Fastener Notice in Service Precautions.

6. Install the manual transmission.