Daytime Running Lamp Control Unit: Service and Repair

REMOVAL PROCEDURE
The DRL module board is enclosed in the plastic case with an integral wiring harness.

CAUTION: Refer to SIR Handling Caution in Cautions and Notices.

1. Disable the SIR System.
2. Remove the instrument panel compartment.
3. Remove the 2 screws which secure the DRL mounting brackets (3) to the instrument panel.
4. Disconnect the DRL control module electrical connector (2).
5. Remove the DRL control module (1) with the mounting brackets attached from the vehicle.
6. Remove the DRL control module (1) from the mounting brackets (3) by releasing the module case clips using a flat-bladed tool.

INSTALLATION PROCEDURE
1. Install the DRL control module (1) to the mounting brackets (3).
2. Install the DRL control module (1) with the mounting brackets attached to the instrument panel. Secure each bracket with 1 screw.
3. Connect the DRL control module electrical connector (2).
4. Install the instrument panel compartment.
5. Enable the SIR System. Refer to "Enabling the SIR System" in Air Bags and Seat Belts.