B1478

Diagnostic Chart (Part 1 Of 2):

Diagnostic Chart (Part 2 Of 2):

Schematic:

CIRCUIT DESCRIPTION
The Body Control Module (BCM) controls the retained accessory power (RAP) feature. The RAP feature allows the following components to operate for 10 minutes (or until a vehicle door opens) after the ignition switch turns from RUN or ACC to LOCK:
^ The radio
^ The power windows
^ The power sunroof, if equipped

The BCM interfaces with the vehicle's power distribution system through the RAP relay. The RAP relay allows the BCM to control the application of power to the RAP controlled feed circuit. When the ignition switch is in either the ACC or the RUN position, the BCM energizes the RAP relay by powering the RAP relay control feed circuit.

The BCM turns off the RAP relay when the ignition switch is in the START position. The RAP feature therefore disables during engine crank and bulb test.

When the ignition switch turns from RUN to LOCK or OFF with all the vehicle doors closed, the BCM leaves the RAP relay energized for 10 minutes, or until any vehicle door opens (the BCM detects a ground signal in one of the door ajar circuits).

CONDITIONS FOR RUNNING THE DTC
The BCM must not be commanding the RAP relay to energize after the RAP feature ten minute time-out or after a door has been opened during the ten minute time-out.

CONDITIONS FOR SETTING THE DTC
^ The BCM detects a short to battery or open in the RAP relay control feed circuit when it is not trying to energize the RAP relay.
^ The condition above must be present for more than 0.3 seconds.

ACTION TAKEN WHEN THE DTC SETS
The BCM stores DTC B1478 in memory.

CONDITIONS FOR CLEARING THE DTC
^ A current DTC B1478 will clear if the short to battery or open in the RAP relay control feed circuit is no longer detected by the BCM when the RAP relay is not commanded to engergize.
^ A history DTC B1475 will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present.
^ A scan tool may be used to clear the DTC.

DIAGNOSTIC AIDS
^ If the DTC B1478 is a history DTC, the fault may be intermittent. Refer to Testing for Intermittent and Poor Connections.
^ The following conditions may cause an intermittent malfunction to occur:
- An intermittent short to battery or open in the RAP relay control feed circuit
- The RAP relay coil is intermittently shorted to battery or open internally
- The BCM is intermittently shorted to battery or open internally

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. Listen for an audible click when the Retained Accessory Relay operates. Command both the ON and OFF states. Repeat the commands as necessary.
3. Verifies that the Body Control Module is providing voltage to the Retained Accessory Relay.
4. Tests for an open in the ground circuit to the Retained Accessory Relay.
5. Tests if voltage is constantly being applied to the Retained Accessory Relay.