Instrument Cluster Gages Inoperative

Instrument Cluster Gages Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

Circuit/System Description

This diagnostic procedure applies to serial data gages located in the instrument panel cluster (IPC) which include the speedometer, tachometer, engine coolant temperature gage and volt gage if equipped.

Reference Information
Schematic Reference

Instrument Cluster Schematics (Instrument Cluster Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Instrument Cluster Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
* Lifting and Jacking the Vehicle (Service and Repair)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Important: If the suspect gage is the speedometer, the drive wheels of the vehicle must be raised and the transmission must be placed in drive or first gear.

1. Ignition ON, perform the IPC gage sweep test with the scan tool. Verify that all the gages sweep from their low to high position.

• If any gages do not sweep from their low to high position, replace the IPC.

2. Engine ON, transmission in drive or first gear, verify the scan tool Vehicle Speed parameter matches the speedometer display.

• If the Vehicle Speed parameter does not match the speedometer display, test or replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for the IPC replacement, setup and programming