Antenna, Radio: Service and Repair

Radio Antenna Replacement

Removal Procedure





1. Remove the headlining trim assembly. Refer to Headlining Trim Panel Replacement Service and Repair.

2. Disconnect the radio antenna module electrical connector.

3. Remove the radio antenna module ground point to roof panel retaining bolt (2).

4. Remove the radio antenna module to roof panel retaining bolt (3).

5. Remove the radio antenna module to roof panel retaining clip (1).

6. From outside the vehicle, remove the radio antenna module and harness from the vehicle.

Installation Procedure





1. From outside the vehicle, install the radio antenna module and harness to the vehicle by threading through the cavity.

2. Install the radio antenna module to roof panel retaining clip (1).

Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the radio antenna module to roof panel retaining bolt (3).

Tighten the bolt to 4 Nm (35 lb in).

4. Install the radio antenna module ground point to roof panel retaining bolt (2).

Tighten the bolt to 2 Nm (18 lb in).

5. Connect the radio antenna module electrical connector.

6. Install the headlining trim assembly. Refer to Headlining Trim Panel Replacement Service and Repair.