Front Seat Replacement - Bucket

Front Seat Replacement - Bucket

Removal Procedure

Warning: Refer to Battery Disconnect Warning Battery Disconnect Warning.


Warning: Refer to SIR Warning SIR Warning.


Note: Before disconnecting the battery ground cable, ensure that the front seat is in the forward and raised position.

1. Disconnect the battery ground cable from the battery. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

2. Disable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.

3. Remove the front seat outer rear adjuster cover. Refer to Driver or Passenger Seat Outer Adjuster Rear Finish Cover Replacement Driver or Passenger Seat Outer Adjuster Rear Finish Cover Replacement.

4. Remove the front seat inner rear adjuster cover. Refer to Driver or Passenger Seat Inner Adjuster Rear Finish Cover Replacement Driver or Passenger Seat Inner Adjuster Rear Finish Cover Replacement.

5. Remove the front seat outer front adjuster cover. Refer to Driver or Passenger Seat Outer Adjuster Front Finish Cover Replacement Driver or Passenger Seat Outer Adjuster Front Finish Cover Replacement.

6. Remove the front seat inner front adjuster cover. Refer to Driver or Passenger Seat Inner Adjuster Front Finish Cover Replacement Driver or Passenger Seat Inner Adjuster Front Finish Cover Replacement.

7. Remove the front seat belt anchor plate tensioner. Refer to Front Seat Belt Anchor Plate Tensioner Replacement Front Seat Belt Anchor Plate Tensioner Replacement





Note: Prior to disconnecting the electrical connectors, reconnect the battery and lower the seat in order to remove the front seat from the vehicle. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

8. Disconnect the front seat electrical connectors (1), release the cable guide (2) and disconnect the pretensioner electrical connector (3).




9. Remove the front seat rear retaining bolts (1).

Note: Removal of the head rest will aid in removal of the front seat. Refer to Driver or Passenger Seat Head Restraint Replacement (Without UWF) Driver or Passenger Seat Head Restraint Replacement (Without UWF).

10. With the aid of an assistant remove the front seat, by lifting and tilting the seat forward, and then lifting and pulling the seat rearwards to disengage the front hooks.

Installation Procedure





Note: Physically inspect each hook to ensure it is correctly engaged.

1. Engage the front seat retaining hooks into the slots in the body and slide the seat forward and down.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the front seat retaining bolts (1) and tighten to 45 Nm (33 lb ft).




3. Connect the front seat electrical connectors (1), route the harness through the cable guide (2) and connect the tensioner electrical connector (3).

4. Install the front seat belt anchor plate tensioner. Refer to Front Seat Belt Anchor Plate Tensioner Replacement Front Seat Belt Anchor Plate Tensioner Replacement

5. Install the front seat outer rear adjuster cover. Refer to Driver or Passenger Seat Outer Adjuster Rear Finish Cover Replacement Driver or Passenger Seat Outer Adjuster Rear Finish Cover Replacement.

6. Install the front seat inner rear adjuster cover. Refer to Driver or Passenger Seat Inner Adjuster Rear Finish Cover Replacement Driver or Passenger Seat Inner Adjuster Rear Finish Cover Replacement.

7. Install the front seat outer front adjuster cover. Refer to Driver or Passenger Seat Outer Adjuster Front Finish Cover Replacement Driver or Passenger Seat Outer Adjuster Front Finish Cover Replacement.

8. Install the front seat inner front adjuster cover. Refer to Driver or Passenger Seat Inner Adjuster Front Finish Cover Replacement Driver or Passenger Seat Inner Adjuster Front Finish Cover Replacement.

Warning: Refer to SIR Warning SIR Warning.


9. Enable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.

10. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

11. Test the front seat for correct mechanical and electrical operation.