Steering Wheel Inflatable Restraint Module Replacement
Steering Wheel Inflatable Restraint Module Replacement
Special Tools
EL-48508 - Removing the Drivers Airbag
Removal Procedure
1. Disable the SDM, refer to SIR Disabling and Enabling Service and Repair.
2. Rotate the steering wheel 90 degrees from the straight-ahead position to expose the access aperture hole in the rear of the steering wheel hub.
3. Using tool no. EL-48508 - removing the drivers airbag, insert into the aperture and pivot towards the instrument panel moving the tool in an outward direction. This will relieve the tension on the spring-loaded retaining clips. The inflatable restraint assembly will move slightly away from the steering wheel. Rotate the steering wheel 180 degrees to expose the remaining access aperture hole. Repeat for other side.
4. Carefully lift the steering wheel inflatable restraint assembly away from the steering wheel and disconnect the wiring harness connectors (Orange and Blue) from the rear assembly.
5. Using a suitable tool, press in on the locking tab (1) while lifting the connector (2) away from the module.
6. Remove the black earth connector from the bottom of the steering wheel inflatable restraint assembly.
7. Refer to Inflatable Restraint Module Handling and Scrapping Procedures.
Installation Procedure
1. Connect the wiring harness connectors (2) to the corresponding colors on the inflatable restraint steering wheel module.
2. Connect the black earth connector on the bottom of the steering wheel inflatable restraint assembly.
3. Align the steering wheel module firmly into the steering wheel assembly applying even pressure to the module until you hear a click.
4. Enable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.
5. After replacing the module, deploy the old module before disposal. If the module replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflatable Restraint Module Handling and Scrapping Procedures.
6. If re-programming is required. Refer to Control Module References Control Module References.