Engine Mount: Testing and Inspection

Engine Mount Inspection

Notice: Refer to Engine Mounting Notice in Service Precautions.





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Inspect for loose or missing bolts at the following locations:
^ The engine mount bracket to the engine.
^ The engine mount to the frame.
3. Replace loose or missing bolts.





4. Remove the starter, when checking the right side only.

Notice: When raising or supporting the engines for any reason, do not use a jack under the oil pan. any sheet metal, or the crankshaft pulley. Lifting the engine in an unapproved manner may cause component damage.

5. Using a jack on the square tab at the leaf of the engine block raise the engine in order to complete the following tasks:
^ Remove weight from the engine mount
^ Place a slight tension on the rubber cushion
^ Observe the engine mount while raising the engine.
6. Replace the engine mount if the following conditions exist:
^ Heat check cracks cover the hard rubber surface.
^ The rubber cushion is separated from the metal plate of the engine mount
^ There is a split through the rubber cushion.
7. Lower the vehicle.