DTC 011
DTC 011
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.
DTC Descriptor
DTC 011
- Accessory Inflator Valve Circuit
Diagnostic Fault Information
Circuit/System Description
The automatic level control sensor monitors the accessory inflator valve circuit for a short to ground, or an open/high resistance circuit.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
* Open in the control circuit of the accessory inflator valve.
* Short to ground in the control circuit of the accessory inflator valve.
* A malfunctioning accessory inflator valve.
Action Taken When the DTC Sets
* The automatic level control sensor disables inflator functions.
* Leveling functions shall continue.
* A malfunctioning accessory inflator valve.
Conditions for Clearing the DTC
The conditions that caused the DTC to set have been removed.
Diagnostic Aids
When this DTC occurs, DTCs 032 and 033 will set.
Reference Information
Schematic Reference
Automatic Level Control Schematics (Electrical Diagrams)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Automatic Level Control Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning)for scan tool information
Circuit/System Verification
Verify that automatic level control functions are disabled.
Circuit/System Testing
1. Ignition OFF, disconnect the accessory inflator valve harness connector at the automatic level control sensor.
2. Ignition ON, verify that a test lamp illuminates between the accessory inflator valve B+ circuit and ground.
• If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the automatic level control sensor.
3. Ignition ON, connect a test lamp between the accessory inflator valve control circuit and the B+ circuit of the accessory inflator valve. Command the accessory inflator valve ON and OFF.
• If the test lamp does not illuminate, test the control circuit for a short to ground or open. If the circuit tests normal, test or replace the automatic level control sensor.
• If the test lamp illuminates, test or replace the accessory inflator valve.
4. If all circuits test normal, test or replace the automatic level control sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Important: System untested code will continue to flash until self test has been completed after the automatic level control sensor replacement.
* Inflator Solenoid Replacement (Inflator Solenoid Replacement)
* Control Module References (Programming and Relearning)for automatic level control module replacement, setup, and programming