Intake Manifold - Installation

INSTALLATION





1. Position intake manifold.
2. Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 12 Nm (106 in. lbs.).
3. Connect electrical connectors for the following components:
- Manifold Absolute Pressure (MAP) Sensor
- Fuel Injectors
- ETC ( Electronic Throttle Control )

4. Connect Brake booster hose, purge hose, and MUA hose ( Make Up Air hose ).
5. Install air inlet hose.
6. Connect negative cable to battery.
7. Install engine covers (1).