Intake Manifold - Installation

INSTALLATION





1. Position intake manifold.
2. Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 12 Nm (105 in. lbs.)
3. Install EGR tube.
4. Install wire harness on intake manifold.
5. Connect electrical connectors for the following components:
- Manifold Absolute Pressure (MAP) Sensor
- Fuel Injectors
- Electronic Throttle Control (ETC)

6. Install ignition wires.
7. Connect Brake booster hose, purge hose, and MUA hose (Make Up Air hose )
8. Install air inlet hose.
9. Connect negative cable to battery.
10. Install engine cover.