Steering Column Opening Cover - Installation

INSTALLATION





1. If removed, position the instrument panel steering column cover reinforcement (1) onto the bracket (2).
2. Install the screws (3) that secure the instrument panel steering column cover reinforcement to the bracket. Tighten the screws securely.





3. Position the steering column cover (1) into the vehicle.
4. Connect the release cable (4) to the emergency brake release handle (5).
5. Connect the wire harness connector (3) to the trunk release switch, if equipped.
6. Install the steering column cover onto the instrument panel and carefully push on the top and right side of the cover to fully seat the snap clip retainers into the instrument panel.
7. Install the screws (2 and 6) that secure the steering column cover (1) to the instrument panel. Tighten the screws securely.

8. Connect the negative battery cable.

NOTE: For vehicles equipped with the optional Automatic Express Up power window feature, recalibration of this feature is required whenever power to the door module is disrupted. Battery Reconnection