Center Mounted Brake Lamp - Installation

INSTALLATION





1. Check to be certain that the two screw and retainer units (1) are properly installed and in good condition in the inner deck lid reinforcement.
2. Position the Center High Mounted Stop Lamp (CHMSL) (2) to the inside of the deck lid (5).
3. Install and tighten the two nuts (4) that secure the CHMSL to the two screw and retainer units in the inner deck lid reinforcement. Tighten the nuts securely.
4. If the vehicle is so equipped, reconnect the body wire harness connector to the Passive Entry (PE) deck lid release switch pigtail wire connector on the back of the CHMSL housing.
5. Reconnect the body wire harness connector (3) to the connector receptacle integral to the back of the CHMSL housing.
6. Reconnect the battery negative cable.