OCS Verification Test

OCS VERIFICATION TEST
VERIFICATION TEST
1. Remove any special tools or jumper wires and reconnect all previously disconnected components - except the battery.

WARNING: Turn the ignition on, then reconnect the 12-volt battery. Failure to follow these instructions may result in possible serious or fatal injury.

2. Connect the scan tool to the Data Link Connector - use the most current software available.
3. With the scan tool to erase stored DTCs in the Occupant Classification Module (OCM) DTCs.
4. Turn the ignition off, and wait 1five seconds, then turn the ignition on.
5. Wait one minute, using the scan tool read active OCM DTCs and if there are none present read the stored codes.
6. If the scan tool shows any active or stored codes, follow path specified for that trouble code. If no active or stored codes are present, the repair is complete.

Are any DTCs present or is the original condition still present?

Yes

- Repair is not complete. Testing and Inspection Perform the appropriate diagnostic procedure.

No

- If the battery was disconnected for any reason, you must perform the Battery Reconnection procedure. Battery Reconnection
- Perform the AIRBAG VERIFICATION TEST. Airbag System Verification Test.