No Response From AMP (Amplifier)

NO RESPONSE FROM AMP (AMPLIFIER)












1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.

NOTE: Make sure the IOD fuse is installed and battery voltage is between 10.0 and 16.0 volts.

2. With the scan tool, select ECU View.

NOTE: A red "X" will be next to the module that is not communicating, indicating that the module is not active on the Bus network. A green check indicates that the module is active on the Bus network.

Does the scan tool display a red "X" next to the module?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.

2. (A116) FUSED B(+) (I.O.D.) CIRCUIT OPEN OR SHORTED




1. Turn the ignition off.
2. Disconnect the Radio Amplifier C1 harness connector.
3. Using a 12-volt test light connected to ground, check the (A116) Fused B(+) (I.O.D.) circuit.

Does the test light illuminate brightly?

Yes

- Go To 3

No

- Repair the open or short in the (A116) Fused B(+) (I.O.D.) circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. (Z920) GROUND CIRCUIT OPEN




1. Using a 12-volt test light connected to 12-volts, check the (Z920) Ground circuit.

Does the test light illuminate brightly?

Yes

- Go To 4

No

- Repair the open in the (Z920) Ground circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

4. (D265) OR (D264) CAN INTERIOR BUS (125K) CIRCUIT OPEN




1. Measure the resistance of the (D264) CAN Interior Bus (125K) (-) circuit between the TIPM C7 harness connector and the Radio Amplifier C1 harness connector.
2. Measure the resistance of the (D265) CAN Interior Bus (125K) (+) circuit between the TIPM C7 harness connector and the Radio Amplifier C1 harness connector.

Is resistance below 5.0 Ohms on both circuits?

Yes

- Replace the Radio Amplifier.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the open in the (D265) or (D264) CAN Interior Bus (125K) circuit. Inspect the connector for damage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.