Wiper Arm Linkage - Installation

INSTALLATION






NOTE: The front wiper motor can be removed from the wiper linkage module and is serviced independently from the remainder of the wiper linkage module for this vehicle. Wiper Motor - Removal

1. Position the front wiper linkage module (5) into the cowl plenum (6) as a unit.
2. Reconnect the wire harness connector (4) to the connector receptacle for the front wiper motor.
3. Position the knob-like rubber isolator (2) to the slotted bracket (3) on the forward wall of the cowl plenum and push the module inboard far enough to seat the isolator in the bracket.
4. Starting on the outboard side, install and tighten the two screws (2) that secure the wiper linkage module within the cowl plenum. Tighten the screws to 6 Nm (55 in. lbs.).
5. Reinstall the cowl plenum cover/grille panel over the front wiper module. Cowl Panel Cover - Installation.
6. Reinstall both front wiper arms onto the wiper pivots. Wiper Arm - Installation
7. Reconnect the battery negative cable.