Wiper Arm Linkage - Removal

REMOVAL






NOTE: The front wiper motor can be removed from the wiper linkage module and is serviced independently from the remainder of the wiper linkage module for this vehicle. Wiper Motor - Removal

1. Disconnect and isolate the battery negative cable.
2. Remove both front wiper arms from the wiper pivots. Wiper Arm - Removal
3. Remove the cowl plenum cover/grille panel from over the front wiper module (5). Cowl Panel Cover - Removal.
4. Disconnect the wire harness connector (4) from the connector receptacle for the front wiper motor.
5. Remove the two screws (1) that secure the module bracket to the cowl plenum.
6. Pull the front wiper linkage module toward the outboard side of the vehicle far enough to disengage the knob-like rubber isolator (2) from the slotted bracket (3) on the forward wall of the cowl plenum (6).
7. Remove the front wiper linkage module from the cowl plenum as a unit.