Test E: The Subwoofer Is Inoperative/Does Not Operate Correctly - Audiophile
PINPOINT TEST E: THE SUBWOOFER IS INOPERATIVE/DOES NOT OPERATE CORRECTLY - AUDIOPHILENormal Operation
The subwoofer amplifier receives voltage through circuit SBP38 (BN/RD) and ground through circuit GD148 (BK/YE). The subwoofer speakers and subwoofer amplifier are integral to the enclosure and cannot be repaired individually.
To enable the subwoofer amplifier, the audio control module (ACM) sends voltage through the enable/clip circuit SME23 (VT/RD). The circuit acts as both an output (to enable the amplifier) and an input (to detect an amplifier overload condition). A variable resistor in the subwoofer amplifier modifies the voltage signal from the ACM. In the event of an overload, the ACM clips the audio output signal to the amplifier (heard as distortion), in order to prevent damage to the amplifier and speakers.
The clip/enable status is based on the following voltages, as detected by the ACM:
- Less than 0.4 volts: amplifier disabled
- Between 3.8 and 6.7 volts: amplifier enabled
- Greater than 8.5 volts: amplifier clipped
An open in circuit SME23 (VT/RD) will cause the subwoofer to produce no sound, because the enable signal will not reach the subwoofer amplifier. A short to ground or short to voltage can cause severe distortion to be heard in the subwoofer.
- DTC B1154 (Subwoofer #1 Short to Ground) - sets when a short to ground is detected on circuit RME22 (GN/WH) or circuit VME22 (VT/GN). This DTC only sets during the on-demand self-test.
- DTC B1155 (Subwoofer #1 Short to Battery) - sets when a short to voltage is detected on circuit RME22 (GN/WH) or circuit VME22 (VT/GN). This DTC only sets during the on-demand self-test.
- DTC B2913 (Audio Subwoofer Not Connected) - sets when the ACM does not detect the subwoofer through circuit SME23 (VT/RD) during the subwoofer connection test (part of the ACM self-test).
This pinpoint test is intended to diagnose the following:
- Fuse
- Wiring, terminals or connectors
- Subwoofer
- ACM