Pinpoint Test K: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter

Locks, Latches and Entry Systems







Pinpoint Tests

Pinpoint Test K: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter

Normal Operation

When any Integrated Keyhead Transmitter (IKT) button is pressed, the SJB receives and processes the command to provide the appropriate output.

This pinpoint test is intended to diagnose the following:

- Door locks
- Horn system
- Power liftgate release
- Turn signal system
- IKT



PINPOINT TEST K: AN INDIVIDUAL BUTTON/FEATURE IS INOPERATIVE FROM THE RKE TRANSMITTER

NOTE: The panic feature will only operate when the key is in the OFF or LOCK position.

-------------------------------------------------
K1 VERIFY THE DOOR LOCK OPERATION


- Press the LOCK and UNLOCK button on the driver door lock control switch while observing the door lock operation.
- Do the door locks operate correctly?

Yes
GO to K2.

No
GO to Symptom Chart. Symptom Related Diagnostic Procedures

-------------------------------------------------
K2 VERIFY THE HORN OPERATION


- Enter the following diagnostic mode on the scan tool: SJB DataLogger.
- Select the SJB PID (HORN) and active command the horn on.
- Does the horn sound when commanded on?

Yes
GO to K3.

No
REFER to Horn.

-------------------------------------------------
K3 VERIFY THE HAZARD LAMP OPERATION


- Place the hazard switch in the ON position.
- Do the hazard lamps operate correctly?

Yes
For vehicles with a power liftgate, GO to K4.

For vehicles with a manual liftgate, REPLACE the inoperative IKT and PROGRAM the IKT individually or PROGRAM all the IKTs. REFER to Antitheft and Alarm Systems for the programming procedures. If all the IKTs are to be programmed, INFORM the customer that any IKTs not present need to be programmed. TEST the system for normal operation.

No
REFER to Lighting and Horns. Lighting and Horns

-------------------------------------------------
K4 VERIFY THE LIFTGATE RELEASE OPERATION


- Press the liftgate release button on the liftgate.
- Does the liftgate open?

Yes
REPLACE the inoperative IKT and PROGRAM the IKT individually or PROGRAM all the IKTs. REFER to Antitheft and Alarm Systems for the programming procedures. If all the IKTs are to be programmed, INFORM the customer that any IKTs not present need to be programmed. TEST the system for normal operation.

No
Go To Pinpoint Test F. Pinpoint Test F: The Liftgate Latch Release Is Inoperative/Does Not Operate Correctly

-------------------------------------------------