Radio/Stereo: Service and Repair

Satellite Digital Audio Receiver System (SDARS) Module









Removal and Installation

NOTE: This procedure applies to vehicles without navigation only. For vehicle with navigation, the satellite radio receiver is built-in to the Audio Control Module (ACM).

1. NOTE: Module configuration is only required if a new Satellite Digital Audio Receiver System (SDARS) module is being installed.

Upload the SDARS module configuration information to the scan tool.

2. Disconnect the SDARS module antenna cable and electrical connectors.

3. NOTE: Move the passenger seat all the way back to access.

Remove the 2 nuts, the bolt, and the SDARS module.

4. To install, reverse the removal procedure.
- Download the configuration information to the SDARS module.