Fluid Pan: Service and Repair

6F35

Main Control Cover













1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the retainers and the LH splash shield.





3. Remove the transmission fluid drain plug and allow the transmission fluid to drain.





4. Install the transmission fluid drain plug.
- Tighten to 12 Nm (106 lb-in).





5. Remove the 2 nuts, pull the transmission fluid cooler tube bracket and tubes away from the transaxle and position it aside.





6. Disconnect the transaxle electrical connector.





7. Remove the transaxle electrical wiring harness retainers from the transmission fluid pan studbolts.





8. NOTE: Note the location of the stud bolts for assembly.

Remove the 8 bolts, 5 stud bolts and the main control cover.





Installation

1. Clean the main control cover sealing surface and inspect for damage.





2. Apply silicone to the main control sealing surface of the transaxle case.





3. Position the main control cover in place.





4. NOTICE: Inspect the main control-to-main control cover grommet to make sure that the seals is on the inside of the main control cover. Transmission fluid leak will occur.

NOTE: Install the stud bolts in the locations noted during disassembly.

Tighten the 8 main control cover bolts and 5 stud bolts.

- Tighten to 12 Nm (106 lb-in).





5. Position the transmission fluid cooler tube bracket and transmission fluid cooler tube assembly in place and install the 2 nuts.
- Tighten to 9 Nm (80 lb-in).





6. Connect the transaxle electrical connector.





7. Connect the transaxle electrical wiring harness retainers.





8. Install the LH splash shield and the retainers.





9. Fill with clean transmission fluid to the correct level.