Front Controls Interface Module (FCIM)

Front Controls Interface Module (FCIM)

NOTE: Vehicle with navigation shown, others similar.











Removal

1. Remove the instrument panel center finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.

2. Remove the 17 screws (vehicles without navigation) or 8 screws (vehicles with navigation), and remove the Front Controls Interface Module (FCIM).

Installation

1. Align the FCIM to the instrument panel center finish panel so there is a consistent gap at the top of the FCIM.





2. NOTICE: Lightly hand-tighten the screws. Do not use power tools.

Install the 17 screws (vehicles without navigation) or 8 screws (vehicles with navigation).

- Adjust the FCIM, if necessary, by loosening the top screws, then re-tightening.

3. Install the instrument panel center finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.