Washer Pump

Washer Pump





Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the RH front fender splash shield.

3. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: When installing a new washer pump, be careful not to damage the rubber grommet.

NOTE: To prevent spilling washer fluid, drain the washer reservoir before washer pump removal.

Remove the washer pump.
- Disconnect the washer pump electrical connector.

- Disconnect the washer hoses.

- Remove the windshield washer pump.

4. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature pump failure.

To install, reverse the removal procedure.

- Fill the washer reservoir with windshield washer fluid.