Pinpoint Test I: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter
Handles, Locks, Latches and Entry Systems
Pinpoint Tests
Pinpoint Test I: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter
Normal Operation
Remote locking and unlocking of the doors and unlocking the cargo doors is accomplished by the Generic Electronic Module (GEM) receiving a command message from the Remote Keyless Entry (RKE) transmitter. The GEM processes the command and energizes the appropriate relays to lock or unlock the doors.
The GEM will disable the lock and unlock buttons if the ignition key is in any position other than OFF or LOCK. The rear cargo door unlock button works in any ignition position.
This pinpoint test is intended to diagnose the following:
- Cargo door lock
- Door locks
- RKE transmitter
PINPOINT TEST I: AN INDIVIDUAL BUTTON/FEATURE IS INOPERATIVE FROM THE RKE TRANSMITTER
-------------------------------------------------
I1 CHECK THE COMPLETE FUNCTIONALITY OF THE RKE TRANSMITTER
- Press each button on the RKE transmitter.
- Is the RKE transmitter completely inoperative?
Yes
GO to Pinpoint Test H. Pinpoint Test H: The Remote Keyless Entry (RKE) Transmitter Is Inoperative
No
GO to I2.
-------------------------------------------------
I2 CHECK THE DOOR LOCK OPERATION
- Press the lock and unlock buttons on the interior door lock control switch.
- Do the doors lock and unlock?
Yes
GO to I3.
No
GO to Symptom Chart - Electrical. Symptom Related Diagnostic Procedures
-------------------------------------------------
I3 CHECK THE CARGO DOOR LOCK OPERATION
- Enter the following diagnostic mode on the scan tool: GEM DataLogger .
- Select the GEM PID (RELEASE) and active command the rear cargo door to unlock.
- Does the cargo door unlock?
Yes
REPLACE the inoperative RKE transmitter. PROGRAM all RKE transmitters. REFER to Remote Keyless Entry (RKE) Transmitter Programming Transmitter. INFORM the customer that any RKE transmitters not present need to be programmed. TEST the system for normal operation.
No
GO to Pinpoint Test C. Pinpoint Test C: The Cargo Door Lock Is Inoperative
-------------------------------------------------