Blind Spot Module: Service and Repair

Side Obstacle Detection (SOD) Module

NOTE: Rear bumper cover removed for clarity.

NOTE: Left rear quarter panel shown, right side similar.











Bracket

NOTE: Left rear quarter panel shown, right side similar.











Removal and Installation

Side obstacle detection (SOD) module

1. NOTE: Module configuration is only required if a new Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) is being installed. Upload the SOD-L or SOD-R module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI)

2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

3. Remove the 3 rear fender splash shield push pins.

4. Remove the 4 lower rear bumper quarter panel splash shield screws.

5. Remove the rear bumper cover screw and gently flex it to access the SOD-L or SOD-R.
- Remove the screw and washer.

- Disconnect the electrical connector.

6. Remove the SOD-L or SOD-R.

7. To install, reverse the removal procedure.

Bracket only

8. Remove the rear bumper cover. For additional information, refer to Bumpers Service and Repair.

9. Disconnect the SOD-L or SOD-R electrical connector and the wiring harness retainer.

10. With a suitable tool, such as pliers, squeeze the retaining tabs of the bracket located in the luggage compartment behind the side carpet panel.





11. NOTE: The bracket has a strip of adhesion tape that holds the bracket to the vehicle.

With a suitable tool, such as a flat-bladed scraper, pry the bracket away from the vehicle.

12. NOTE: When installing the bracket, make sure the retaining tab portion of the bracket snaps firmly into the vehicle and 2 audible clicks are heard.

To install, reverse the removal procedure.