Parking Assist Control Module: Service and Repair

Parking Aid Module (PAM)









Removal and Installation

1. NOTE: Module configuration is required when a new Parking Aid Module (PAM) is being installed.

Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

2. Remove the RH C-pillar trim panel. For additional information, refer to Interior Trim and Ornamentation C-Pillar Trim Panel.

3. If replacing the parking aid speaker only, proceed as follows:
- Disconnect the electrical connector.

- Disengage the clips.

- Remove the parking aid speaker.

4. If replacing the PAM, proceed as follows:
- Disconnect the electrical connector.

- Remove the 2 pin-type screws.

- Remove the PAM.

5. To install, reverse the removal procedure.
- Download the configuration information to the PAM. For additional information, refer to PMI in Module Configuration Testing and Inspection.