Parking Assist Control Module: Service and Repair

Parking Aid Module (PAM)

NOTE: The Parking Aid Module (PAM) is located above the RH cowl side trim panel.









Removal and Installation

1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.

Upload the PAM (Parking Aid Module) configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programmable Module Installation (PMI)

2. If replacing the Parking Aid Module (PAM), proceed as follows:
- Disconnect the electrical connectors.

- Remove the PAM (Parking Aid Module) push-pins.

- Remove the PAM (Parking Aid Module).


3. If replacing the parking aid speaker only, proceed as follows:
- Disconnect the parking aid speaker electrical connector.

- Disengage the parking aid speaker clips.

- Remove the parking aid speaker.


4. To install, reverse the removal procedure.
- Download the PAM (Parking Aid Module) configuration information.