Traction Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module









Removal and Installation

1. If installing a new ABS module, connect the scan tool and upload the module configuration information from the ABS module.

2. Remove the Air Cleaner (ACL).

3. NOTE: Do not disconnect the hoses from the power steering reservoir.

Remove the 4 bolts and position the power steering fluid reservoir and bracket aside.

- To install, tighten the bolts to 28 Nm (21 lb-ft).






4. Remove the 3 bolts and position the degas bottle aside.
- To install, tighten the bolts to 10 Nm (89 lb-in).






5. Disconnect the ABS module electrical connector.
- Release the lock tab.

- Pull the connector from the module.






6. Remove the 4 screws and the ABS module.
- To install, tighten the screws to 5 Nm (44 lb-in).


7. To install, reverse the removal procedure.
1. If a new ABS module was installed, download the module configuration information from the scan tool.

2. For vehicles equipped with Roll Stability Control (RSC(R)), carry out the IVD Initialization sequence. Follow the scan tool directions.