Pinpoint Test J: The Rear Window Wiper Does Not Park At The Correct Position

Wipers and Washers

Pinpoint Test J: The Rear Window Wiper Does Not Park At The Correct Position

Normal Operation

When the wiper/washer switch is placed in the OFF position, the motor continues to operate until the motor returns to the PARK position and the internal Hall-effect sensor senses the motor magnet. The output to the integral run/park relay deactivates the relay and disconnects the voltage to the motor.

This pinpoint test is intended to diagnose the following:

- Wiper mounting arm and pivot shaft

- Rear wiper motor

PINPOINT TEST J : THE REAR WINDOW WIPER DOES NOT PARK AT THE CORRECT POSITION

J1 CHECK THE REAR WINDOW WIPER PARK RELAY OPERATION

- Ignition ON.

- Place the rear wiper/washer switch to the low speed setting. When the wiper blade is in the middle of a wipe, place the wiper/washer switch off.

Does the rear window wiper immediately stop when the wiper/washer switch is turned off?

Yes
INSTALL a new rear window wiper motor. REFER to Wiper Motor - Rear Window . TEST the system for normal operation.

No
ADJUST the pivot arm. REFER to Wiper Blade and Pivot Arm Adjustment - Rear Window .