Interior Rear View Mirror

Interior Rear View Mirror





NOTE: interior auto-dimming rear view mirror shown, base interior rear view mirror similar.











Removal

NOTICE: The windshield must be at room temperature. Otherwise, damage to the windshield glass may occur.

1. If equipped, disconnect the electrical connector.

2. If equipped, remove the compass module.

3. Insert the Mirror Remover between the interior rear view mirror mount and windshield bracket located at the bottom of the mirror mount.





4. NOTICE: Twisting the interior rear view mirror mount from right to left may cause a stress fracture to the windshield.

NOTICE: Make sure to use the windshield bracket as the pivot point. Otherwise, damage to the windshield will occur.

Release the interior rear view mirror mount from the windshield bracket by pulling the Mirror Remover away from the windshield.





Installation

1. Slide the interior rear view mirror mount over the windshield bracket from the top.





2. Using the Rear View Mirror Installer, press the interior rear view mirror mount downward along the windshield bracket until the mirror mount is fully seated onto the windshield mounting button.





3. If equipped, Install the compass module.

4. If equipped, connect the electrical connector.

5. If equipped, check the compass zone and calibration. For additional information, refer to Electronic Compass Compass Zone Adjustment and Compass Calibration.