Antenna: Service and Repair

Antenna - Satellite Radio









Removal and Installation

NOTE: This procedure applies to both the stand-alone satellite radio antenna and the combination satellite radio/Global Positioning System (GPS) antenna.

1. Remove the headliner. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

2. Remove the satellite radio antenna in the following sequence:

1. Disconnect the satellite radio antenna cable connector.

2. Loosen the satellite radio antenna bolt.
- To install, tighten to 6 Nm (53 lb-in).

3. Remove the satellite radio antenna from the top of the roof.

4. To install, reverse the removal procedure.