Pinpoint Test BB: DTC U0140
Handles, Locks, Latches and Entry Systems - With Intelligent Access (IA)
Pinpoint Tests
Pinpoint Test BB: DTC U0140
Normal Operation
The Driver Door Module (DDM) and the Smart Junction Box (SJB) communicate using the Medium Speed Controller Area Network (MS-CAN). Messages are exchanged between the modules on the MS-CAN for the purposes of determining what functions are being carried out.
- DTC U0140 (Lost Communication With Body Control Module ( GEM)) - set by the DDM if data messages received from the SJB over the MS-CAN are missing for 15 seconds or longer.
This pinpoint test is intended to diagnose the following:
- Module communication
- DDM
- SJB
PINPOINT TEST BB: DTC U0140
-------------------------------------------------
BB1 VERIFY CUSTOMER CONCERN
- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?
Yes
GO to BB2.
No
The system is operating normally at this time. The DTC may have been set due to high network traffic or intermittent fault condition.
-------------------------------------------------
BB2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the SJB pass the network test?
Yes
GO to BB3.
No
REFER to Module Communications Network Testing and Inspection.
-------------------------------------------------
BB3 RETRIEVE THE RECORDED DTCs FROM THE SELF-TEST
- Check for recorded DDM DTCs from the self-test.
- Is DTC B1317 or DTC B1318 recorded?
Yes
For DTC B1317, GO to Pinpoint Test AZ. Pinpoint Test AZ: DTC B1317
For DTC B1318, GO to Pinpoint Test BA. Pinpoint Test BA: DTC B1318
No
GO to BB4.
-------------------------------------------------
BB4 RECHECK THE DDM DTCs
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.
- Clear the DTCs. Repeat the DDM self-test.
- Is DTC U0140 still present?
Yes
GO to BB5.
No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or intermittent fault condition.
-------------------------------------------------
BB5 CHECK FOR DTC U0140/U0140:00 IN OTHER MODULES
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during PMI or the PMI may not have been carried out.
- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0140/U0140:00 set in other modules?
Yes
INSTALL a new SJB. REFER to Multifunction Electronic Modules Smart Junction Box (SJB). TEST the system for normal operation.
No
INSTALL a new DDM. REFER to Driver Door Module (DDM) Service and Repair. TEST the system for normal operation.
-------------------------------------------------