Accessory Drive Belt

Accessory Drive Belt

Removal

NOTICE: Under no circumstances should the accessory drive belt, tensioner or pulleys be lubricated as potential damage to the belt material and tensioner damping mechanism will occur. Do not apply any fluids or belt dressing to the accessory drive belt or pulleys.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the 2 bolts and the accessory drive belt splash shield.





3. Cut and discard accessory drive belt.





Installation

NOTICE: Under no circumstances should the accessory drive belt, tensioner or pulleys be lubricated as potential damage to the belt material and tensioner damping mechanism will occur. Do not apply any fluids or belt dressing to the accessory drive belt or pulleys.

NOTICE: Only rotate the crankshaft clockwise or damage to the engine can occur.

1. Remove and discard the bolt. Install the stud bolt supplied with the new accessory drive belt.
- Tighten the stud bolt to 9 Nm (80 lb-in).






2. Rotate the crankshaft clockwise until the designated hole is at the 5 o'clock position.





3. Install the tools supplied with the new accessory drive belt as shown.
- Install the supplied nut finger tight.






4. NOTE: Without A/C shown, with A/C similar.
Position the accessory drive belt onto the coolant pump, generator and idler pulleys as shown.






5. NOTE: After installation, verify the accessory drive belt is correctly seated on all of the pulleys.
Rotate the crankshaft clockwise 1 full rotation.






6. Remove the nut and the special tools. Leave the stud bolt installed.





7. NOTE: With A/C shown, without A/C similar.
Verify the accessory drive belt is correctly seated on all of the pulleys.






8. Position the accessory drive belt splash shield and install the 2 bolts.
- Tighten to 9 Nm (80 lb-in).