Side Air Curtain Module
Side Air Curtain Module
4-Door Sedan
5-Door Hatchback
Removal and Installation
WARNING: Always carry or place a live Safety Canopy(R), or side air curtain module, with the module and tear seam pointed away from your body. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.
WARNING: Anytime the Safety Canopy(R) or side air curtain module has deployed, a new headliner and new A-, B- and C-pillar upper trim panels and attaching hardware must be installed. Remove any other damaged components and hardware and install new components and hardware as needed. Failure to follow these instructions may result in the Safety Canopy(R) or side air curtain module deploying incorrectly and increases the risk of serious personal injury or death in a crash.
WARNING: Inspect a Safety Canopy(R) or side air curtain module before installation. If the module is damaged, the cover has separated or the Safety Canopy(R) or side air curtain material has been exposed, install a new module. Do not attempt to repair the module. Failure to follow these instructions may result in the Safety Canopy(R) or side air curtain deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
WARNING: Do not obstruct or place objects in the deployment path of the Safety Canopy(R) or side air curtain module. Failure to follow this instruction may result in the Safety Canopy(R) or side air curtain module deploying incorrectly and increases the risk of serious personal injury or death in a crash.
WARNING: Never put any type of fastener or tie strap around any part of a Safety Canopy(R) module, side air curtain module or interior trim panel. This will prevent the Safety Canopy(R) or side air curtain module from deploying correctly. Failure to follow this instruction may increase the risk of serious personal injury or death in a crash.
WARNING: Before installing a Safety Canopy(R) or side air curtain module, inspect the roofline for any damage. If necessary, the sheet metal must be reworked to its original condition and structural integrity. Install new fasteners if damaged and remove foreign material. Failure to follow these instructions may result in the Safety Canopy(R) or side air curtain deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the headliner. For additional information, refer to Interior Trim and Ornamentation Service and Repair.
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures information.
3. Squeeze the tabs and disconnect the side air curtain module electrical connector.
4. Remove all the side air curtain module bolts.
- To Install, tighten to 9 Nm (80 lb-in).
5. Disengage all the side air curtain module pin-type retainers.
6. At all screw attachment points except the rear, lift and rotate the top of the bracket out of the roof sheet metal slots.
- For the rear bracket, pull rearward and rotate out of the roof sheet metal slot.
7. Slide the side air curtain module canister forward and disengage the T-tab bracket from the roof sheet metal slot.
- Remove the side air curtain module.
8. To install, reverse the removal procedure.
9. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures information.