Halfshaft - LH

Halfshaft - LH













Disassembly

1. Remove the LH halfshaft assembly. For additional information, refer to Halfshaft - Exploded View Halfshaft - Exploded View.

2. Clamp the intermediate shaft in a soft-jawed vise.

1. Remove and discard the 2 inner CV boot clamps.

2. Remove the inner CV joint housing.





3. Push the boot back along the shaft.

4. Separate the tripod joint from the housing and remove all of the grease.





5. Remove and discard the snap ring.





6. Using a suitable 3-jaw puller, remove the tripod joint.





7. Remove and discard the inner CV joint boot.





8. Remove and discard the outboard CV boot and boot insert.

1. Remove and discard the 2 boot clamps.

2. Pull the outboard boot down the length of the shaft and off the inboard end.
- Remove the CV joint grease.





Assembly

NOTICE: The inner joint must not be bent at more than 18 degrees; the outer joint must not be bent at more than 45 degrees or damage to the component my occur.

NOTICE: Use care not to damage the boot or component damage may occur.

1. NOTE: Install the outboard CV boot from the inboard end.

Install the outboard CV boot and install half the grease in the sachet (supplied with boot kit) into the outer joint and the remainder in the CV joint boot.

- Slide a small flat-blade screwdriver under the boot seat to allow the air to escape.

- Position the CV boot and remove the screwdriver.

2. Using the Constant Velocity Joint Boot Clamp Installer, install the 2 new outboard boot clamps.





3. NOTICE: Do not damage the tripod joint roller bearings or component damage may occur.

Install the tripod joint on the inboard end of the shaft.

- Using a suitable driver, push the tripod joint onto the front drive halfshaft as far as it will go.





4. Install a new snap ring.





5. Install half of the sachet of grease (supplied with boot kit) into the tripod joint housing. Inject the other half of the grease into the boot.

6. NOTICE: Use care not to damage the boot or component damage may occur.

Install the tripod joint into the tripod joint housing.

1. Insert a small flat-blade screwdriver under the boot seat to allow the air to escape.

2. Slide the tripod joint in as far as it will go, then pull it out 20 mm (0.787 in).

- Remove the screwdriver.





7. Using the Constant Velocity Joint Boot Clamp Installer, install the 2 new CV boot clamps.





8. Install the LH halfshaft assembly. For additional information, refer to Halfshaft - Exploded View Halfshaft - Exploded View.