P1362

DTC P1362: No Signal in TDC1 Sensor Circuit
1. Do the PCM Reset Procedure.
2. Start the engine.
Is DTC P1361, P1362, P1366 or P1367 indicated?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Check for poor connections or loose wires at the TDC1/TDC2 sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the TDC1/TDC2 sensor 4P connector.




5. Measure resistance between the terminals of the indicated sensor (see table).
Is there 1,850-2,450 ohm ?
YES-Go to step 6.
NO-Replace the TDC1/TDC2 sensor.




6. Check for continuity to body ground on both terminals of the indicated sensor individually.
Is there continuity?
YES-Replace the TDC1/TDC2 sensor.
NO-Go to step 7.
7. Reconnect the TDC1/TDC2 sensor 4P connector.
8. Disconnect the PCM connector C (31P).




9. Measure resistance between the terminals of the indicated sensor on the PCM connector (see table).
Is there 1,850-2,450 ohm ?
YES-Go to step 10.
NO-Repair open in the indicated sensor wires (see table).




10. Check for continuity between body ground and PCM connector terminals C20 and/or C29 individually.
Is there continuity?
YES-Repair short in the indicated sensor wires (see table).
NO-Substitute a known-good PCM and recheck.
If the symptom/indication goes away, replace the original PCM.