P0962
DTC P0962: Problem in A/T Clutch Pressure Control Solenoid Valve A CircuitNOTE:
^ Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information.
^ This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
1. Clear the DTC with the HDS.
2. Test-drive the vehicle for several minutes in the D position through all five gears.
3. Check that DTC P0962 recurs.
Is DTC P0962 indicated?
YES - Go to step 7.
NO - Go to step 4.
4. Choose Clutch Pressure Control Solenoid Control in Miscellaneous Test Menu, and test the A/T clutch pressure control solenoid valve A with the HDS.
Is the result NORMAL?
YES - Go to step 5.
NO - Go to step 7.
5. Command the A/T clutch pressure control solenoid valve A at 1.0 A in Clutch Pressure Control Solenoid Control menu.
6. Monitor the OBD status for P0962 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate FAILED?
YES - Go to step 7.
NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/T clutch pressure control solenoid valve A and the PCM. If the HDS indicates NOT COMPLETED, return to step 4 and recheck.
7. Turn the ignition switch OFF.
8. Disconnect the A/T clutch pressure control solenoid valve A connector.
9. Measure resistance between A/T clutch pressure control solenoid valve A connector terminals No. 1 and No. 2.
Is there 3 - 10 Ohms?
YES - Go to step 10.
NO - Replace the A/T clutch pressure control solenoid valve A, then go to step 13.
10. Check for continuity between A/T clutch pressure control solenoid valve A connector terminal No. 2 and body ground.
Is there continuity?
YES - Go to step 11.
NO - Repair open in the wire between the A/T clutch pressure control solenoid valve A and ground (G101), or repair poor ground (G101), then go to step 13.
11. Turn the ignition switch ON (II).
12. Measure voltage between A/T clutch pressure control solenoid valve A connector terminals No. 1 and No. 2.
Is there battery voltage?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck for DTC P0962. If the symptom/indication goes away with a known-good PCM, replace the original PCM, then go to step 13.
NO - Repair open or short in the wire between PCM connector terminal B35 and A/T clutch pressure control solenoid valve A, then go to step 13.
13. Clear the DTC with the HDS.
14. Test-drive the vehicle for several minutes in the D position through all five gears.
15. Monitor the OBD status for P0962 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate PASSED?
YES - Troubleshooting is complete.
NO - If the PCM was updated and the screen indicates FAILED, substitute a known-good PCM, then return to step 13. If the PCM was substituted and the screen indicates FAILED, return to step 1 and recheck. If the screen indicates NOT COMPLETED, return to step 14.