P0974

DTC P0974: Open in Shift Solenoid Valve A Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

1. Clear the DTC with the HDS.
2. Start the engine in the P position, and keep the shift lever in the P for more than 1 second.
3. Check that DTC P0974 recurs.
Is DTC P0974 indicated?
YES - Go to step 7.
NO - Go to step 4.

4. Choose Shift Solenoid A in Miscellaneous Test Menu, and test the shift solenoid valve A with the HDS.
Is a clicking sound heard?
YES - Go to step 5.
NO - Go to step 7.

5. Start the engine in the P position, and keep the shift lever in the P for more than 1 second.
6. Monitor the OBD status for P0974 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate FAILED?
YES - Go to step 7.
NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at shift solenoid valve A and the PCM. If the HDS indicates NOT COMPLETED, return to step 4 and recheck.

7. Turn the ignition switch OFF,
8. Jump the SCS line with the HDS.
9. Disconnect PCM connectors B (44P) and C (44P).





10. Measure resistance between PCM connector terminals B10 and C40.
Is there 12 - 25 ohms?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM,then recheck for DTC P0974. If the symptom/indication goes away with a known-good PCM, replace the original PCM, then go to step 15.
NO - Go to step 11.

11. Disconnect the shift solenoid harness connector.





12. Check for continuity between PCM connector terminal B10 and shift solenoid harness connector terminal No. 5.
Is there continuity?
YES - Go to step 13.
NO - Repair open in the wire between PCM connector terminal B10 and the shift solenoid harness connector, then go to step 15.

13. Remove the shift solenoid harness.





14. Check for continuity between shift solenoid harness connector terminal No. 5 and shift solenoid valve A connector terminal.
Is there continuity?
YES - Replace shift solenoid valve A, then go to step 15.
NO - Replace the shift solenoid harness, then go to step 15.

15. Clear the DTC with the HDS.
16. Start the engine in the P position, and keep the shift lever in the P for more than 1 second.
17. Monitor the OBD status for P0974 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate PASSED?
YES - Troubleshooting is complete.
NO - If the PCM was updated and the screen indicates FAILED, substitute a known-good PCM, then return to step 15. If the PCM was substituted and the screen indicates FAILED, return to step 1 and recheck. If the screen indicates NOT COMPLETED, return to step 16.