B2986

DTC B2986 or DTC indicator A and AUTO: An Open in the Recirculation Control Motor Circuit

1. Clear the DTC with the HDS.
2. Turn the ignition switch to LOCK (0), and then turn to ON (II).
3. Do the self-diagnostic with the HDS or climate control unit.
4. Check for DTCs.

Is DTC B2986 or A and AUTO?

YES - Go to step 5.

NO - Intermittent failure, check for loose wires or poor connections on the recirculation control motor circuit.

5. Turn the ignition switch to LOCK (0).
6. Test the recirculation control motor.

Is the recirculation control motor OK?

YES - Go to step 7.

NO - Replace the recirculation control motor.

7. Disconnect the recirculation control motor 7P connector.
8. Disconnect climate control unit connector A (32P).
9. Check for continuity between the following terminals of climate control unit connector A (32P) and the recirculation control motor 7P connector.






Is there continuity?

YES - Check for loose wires or poor connections at climate control unit connector A (32P) and at the recirculation control motor 7P connector. If the connections are good, substitute a known-good climate control unit and recheck. If the symptom/indication goes away, replace the original climate control unit.

NO - Repair open in the wire(s) between the climate control unit and the recirculation control motor.